Before & After Gallery - Servo Garage Doors Coral Springs

Garage Door Before & After in Coral Springs, FL

Talk is cheap in the garage door trade. Every company says they do clean work. We’d rather show you. The projects below are the kinds of jobs we handle most weeks across Coral Springs, from broken springs in Heron Bay to full door replacements in Ramblewood. Each one follows the same rule from start to finish: a written price before any work begins, and a photo record of what we found and what we fixed after the job is done. That’s Clause 1 and Clause 4 of The Haven Standard, and we’ve worked that way since 2015.

Call (754) 399-3666

Recent Transformations

Torsion Spring Replacement on a Two-Car Door in Westchester

The problem: A homeowner in Westchester called at 7:15 a.m. with a door that wouldn’t lift. The left torsion spring had snapped clean at the coil, which put the full lift load on the remaining spring and the opener. That’s a fast way to burn out a motor. The spring measured 0.250-inch wire diameter, a standard for 16-by-7 doors in this area.

What we did: We replaced both springs as a matched pair. You don’t replace one spring on a two-spring door and call it done; the older spring is already near the end of its cycle life. We installed new torsion springs rated for the door’s weight, lubed the bearings, and re-balanced the door so it holds at the halfway point without creeping up or dropping.

The result: Door opens smoothly at about 12 seconds per cycle, balanced enough that the opener isn’t working harder than it should. The customer received photos of the broken spring before we quoted the replacement, and a written price before the first tool came off the truck.

Full Door Replacement After Hurricane-Force Wind Damage in Maplewood

The problem: Another Coral Springs home in Maplewood had a door that had gone through several hurricane seasons and had finally buckled along the bottom panel. The panel seam was separated enough to see daylight through it, and the door no longer sealed against the floor. That’s a security issue as much as an energy issue. We see this pattern often in neighborhoods built in the 1990s.

What we did: We replaced the door with a new Clopay steel model rated for Florida wind load, including new track, rollers, and weatherseal. The old track was still serviceable, but pairing new door with older track just transfers wear. We wrote the full scope before work started, so the customer knew exactly what was being replaced and why.

The result: The garage now seals tight against summer heat and afternoon rain. The door operates quieter than the old one ever did, and the customer has a documented photo record of the old damage and the finished install.

Opener Logic Board Failure and Motor Replacement in the Greens

The problem: In The Greens, a customer’s LiftMaster opener would click but not run. The logic board had failed after a series of power surges. The motor itself was still fine, but on a unit that age, replacing the board alone often means the next failure is a week away. Marcus Deller, Owner at Servo Garage Doors Coral Springs, has been making that call since 2015: repair when repair makes sense, replace when repair just delays the next bill.

What we did: We replaced the opener with a new LiftMaster motor and new safety sensors, then reprogrammed the remotes and keypad. We also checked the door balance before installing the new motor. A new opener on an unbalanced door voids the warranty and shortens the motor’s life.

The result: The customer now has a door that responds on the first click, with sensors aligned and tested. They also received a written warranty and the photo record we take on every visit. That’s part of the 365-Day Done Right Promise, backed by The Haven Standard, not a handshake.

Bent Track and Roller Replacement in Kensington

The problem: A Kensington door had been forced open manually after the opener failed, and the vertical track took the damage. The door was binding every few inches on the way up, which is the sound people describe as a grinding noise. A bent track doesn’t fix itself; it just wears out rollers faster and puts strain on the hinges.

What we did: We replaced the bent track section with new galvanized steel track, swapped the metal rollers for nylon rollers which run quieter, and checked every bracket for stress. The hinge line was still straight, so no panel work was needed. We quoted the track and roller work before starting, and the final price matched the written quote exactly.

The result: The door moves up and down without binding, and the grinding noise is gone. The customer’s photo record shows the bent track as we found it and the new track after installation.

Cable Replacement on a Single-Car Door in Cypress Run

The problem: In Cypress Run, a single-car door was hanging unevenly because the lift cable had frayed to about half its original thickness. The cable hadn’t snapped yet, but it was days or cycles away. A snapped cable under tension can whip hard enough to cause serious injury, which is why this job goes to a trained professional, not a YouTube tutorial.

What we did: We replaced both lift cables, re-seated the drums, and re-tensioned the system. We also checked the spring condition while we were in there. The springs were original to a 2011 door and near the end of their expected cycle life, but they measured within spec, so we documented the reading and told the customer what to expect in the next 12 to 18 months. No pressure, no upsell, just the facts.

The result: The door sits level, lifts straight, and the cables are no longer a safety liability. The customer received photos of the frayed cable before we touched it.

Want Results Like These?

If your garage door is loud, stuck, uneven, or just old enough to worry about, we’ll come take a look. You’ll get a written price before any work begins, and a photo record of whatever we find or fix when the job is done. That’s how we’ve handled 18,000+ doors in Coral Springs since 2015. Call (754) 399-3666, day or night. A person answers, not a recording, and we’ll have a technician on the way.

Written by Marcus Deller, Owner at Servo Garage Doors Coral Springs, serving Coral Springs since 2015.